Hailstones are an unpredictable and devastating atmospheric phenomenon for car bodies. However, no location is completely free from this risk. There is no way to avoid it except to protect the vehicle in a covered area.
Falling ice between 5 and 50 mm in diameter causes dents and hail damage to all types of cars. The question, when hail has affected the car, is how Dallas hail damage.
As a general rule, hail damage to the car is characterized by numerous dents in which the paint does not usually pop off. The most affected parts are generally the hood, trunk, and roof. Depending on the severity of the hail damage to the car, it is possible to repair these areas or, in the worst case, it will be necessary to replace them. A specialized Dallas hail damage specialist’s intervention is often decisive in determining how to remove hail dents.
The traditional method of hail dent repair:
The process begins by removing (scraping) the original paint with the help of a radial saw. This is done to weld the tip of the spot part and thus draw the sheet metal out. This mechanism works by inertia. This is the most common procedure for easily accessible areas where it is possible to work with a hammer and Tas.
When the plate is in a more or less flat position, it is then filled with putty—thus eliminating any deformations that may remain.
When the putty has dried, they will proceed to sand the area. The next step will be the primer and the subsequent painting.
Repair method using rods and suction cups:
The repair with rods consists of pushing the vehicle’s sheet metal from the inside of the car. The process is carried out by massaging with polished round-tipped rods. The tip is treated to avoid the appearance of spikes that damage the original texture.
A light is placed flush with the sheet metal to identify all the dents on the vehicle—even the smallest ones. Thanks to this light, they can read to perfection the sheet metal zone that has been affected and act with the best accuracy to repair hail cars. In the morning, they can identify the minor imperfections. While in the traditional method, with the hand, they cannot be placed.
Suppose your current economic situation does not allow certain expenses and encourages many owners to look for alternative solutions to remove hail dents. The first domestic use that is usually applied is the alternative use of heat and cold: it is done by placing the car under the scorching sun or, if this is not possible, by applying a hair dryer, at maximum power, about 12-18 cm away from each bun for a couple of minutes. Of course, the process must be stopped immediately if the paint discolors. Otherwise, continue placing ice on the dent and moving it circularly to generate a thermal contrast that causes the initial appearance recovery.
Another possibility is to buy a dent repair kit or a suction cup to remove dents in a store or on the Internet. It is essential to choose the fitting kit: it must be adequate, high-quality, and appropriate for the specific vehicle. Suction cups are usually a simple and inexpensive solution that does not require any experience to use with some success. In conclusion, when someone is considering removing hail bolls from their car, the immediate decision is to go to a specialized Dallas hail damage. For safety, quality, and convenience, doing so is the best alternative. Although saving money is reason enough to try other more homemade methods to work, they take the necessary care.